Sito internet assistenza tecnica

Accedi
Italiano Italiano THRUSTMASTER.COM
Thrustmaster

RACELINE LC UPGRADE

Numero prodotto 4060385 4060389
RACELINE LC UPGRADE
Manuale Software Contattaci per questo prodotto

Attenzione

IF THE PEDAL SET IS CONNECTED TO A NON-DIRECT-DRIVE THRUSTMASTER RACING WHEEL BASE VIA THE RJ12 PORT
= T150 / TMX / T128 / T248 / T248-R / T300 / TX / T-GT / T-GT II / TS-XW / TS-PC RACER


In this case:
# No firmware update for the pedal set is required.
# The racing wheel base must be set to T3PA mode (not T-LCM mode).
 # Use the Thrustmaster Raceline LC Tools software (v2.55) available in the Software section to modify the calibration of the LC (Load Cell) brake pedal

Notes:
- With this software, the pedal set must be connected via USB directly to the PC (the RJ12 cable must be disconnected from the racing wheel base).
The applied calibration is saved in the pedal set’s internal memory and is therefore functional (whether on PC or consoles) once the pedal set is connected via RJ12 to the racing wheel.
- It is not possible to modify the calibration of the gas or clutch pedals.


IF THE PEDAL SET IS CONNECTED TO A THRUSTMASTER T598 DIRECT DRIVE RACING WHEEL BASE VIA THE RJ45 PORT (DIO PORT) = T598 (but not T818)


In this case:
# It is imperative to update the firmware of the pedal set and the T598 base:
- Raceline LC (Load Cell) pedal set: Firmware v2.53 (*)
- T598-P: Firmware v3.08
- T598-X: Firmware v1.60
 (*) : The Raceline LC firmware update can be performed (via My Thrustmaster Panel) with the pedal set connected via RJ45 to the T598 or with the pedal set connected via USB to the PC.

# The pedal set is is recognized with the name TRLP-LC on the T598 screen, in the PEDAL SET tab.
# Adjust the pedal set parameters (MIN / MAX / CURVES / ...) via the T598 screen (in TRLP-LC tab) or using the My Thrustmaster Panel software (available in the Software section).
Calibration via the screen can be performed directly within games, whether on consoles or on a PC.
The applied calibration is saved in the pedal set’s internal memory.

Note
- If the pedal set is connected via USB (directly to the PC), the RJ45 cable must be disconnected from the T598.
- The pedal set cannot be connected to a T818 base via RJ45.


IF THE PEDAL SET IS CONNECTED TO A THRUSTMASTER T818 DIRECT DRIVE RACING WHEEL BASE OR TO A NON-THRUSTMASTER RACING WHEEL BASE VIA USB


In this case:
# It is imperative to update the firmware of the pedal set and the T598 base:
- Raceline LC (Load Cell) pedal set: Firmware v2.53
# Use the My Thrustmaster Panel available in the Software section to adjust the pedal set parameters (MIN / MAX / CURVES / …). The applied calibration is saved in the pedal set’s internal memory.
Per saperne di più

Manuale

Software

  • softwareMy Thrustmaster Panel [VERSION: 1.3.234.0]
    PC
  • Note sulla versione Note sulla versione - My Thrustmaster Panel [VERSION: 1.3.234.0]
  • softwareThrustmaster Raceline LC Tools software (v2.55)
    PC